1974 International Scout II Half Cab 4x4 AMC 258 3spd manual transmission
1974 International Harvester Scout
Technical specifications of International Harvester Scout 1974 | |
---|---|
Price: | - |
Condition: | Used |
Item location: | Brewton, Alabama, United States |
Make: | International Harvester |
Model: | Scout |
Year: | 1974 |
Mileage: | 15,555,555 |
Engine size: | 258 |
Number of cylinders: | 6 |
Fuel: | Gasoline |
Drive type: | 4WD |
Options: | 4-Wheel Drive |
Vehicle Title: | Clear |
You are interested? | Contact the seller! |
Car description |
---|
Have owned this Scout for years and is my daily driver.
It does need some work, but is a running driving Scout. Looking to pass it on to a good home. I honestly don't have time to work on it anymore, and when I do have free time I don't want to do anything.
Does have rust and needs a right quarter and floor pans. Frame and all cab mounts are solid, just need some panel replacement.
Lifters clatter and need to be replaced, they don't tap as much when the engine is warmed up, and the Scout runs and drives strong. Have gasket set for the lifter job, haven't purchased the lifters yet.Power steering box is leaking, have replaced the input shaft seal, needs end cap o-ring. Has the Flaming River steering shaft and u-joint kit installed.
upper ball joints are getting a little sloppy. I have been rounding up parts to go thru the front end. have new Moog drag link, Moog steering damper, wheel bearings, seals....
over the years I have......
re-wired w/ a Painless wiring fuse block-
Sunpro gauges: Tach, Oil, Temp, Volt, Vacuum, Fuel. Optima Red Top
Energy suspension cab mounts and leaf spring bushings. 1" body lift w/ Rough Country add-a-leafs front/rear.
Warn hubs, shocks, brakes, brake master cylinder, braided stainless rear hose, U-joints
US Wheels: 15x8 white mods w/ 31x10.50's. tires are 85 percent. full size spare.
Toolbox has keys
'85 Jeep aluminum intake manifold w/ Motorcraft 2100 carburetor.
Jeep exhaust manifold and ran new pipe w/ quiet muffler and tip
'85 Jeep front v-belt drive w/ power steering and GM 10si alternator
GM HEI distributor. fuel pump about 9 months ago.
Lucas in Dana 44 front and rear, transmission and transfercase.
Parts that go w/ it, I'm sure I'm forgetting some things.
Almost perfect, in primer, windshield frame w/ new windshield rubber gasket and new "Anything Scout" stainless wipers
left front solid inner fender, has been painted ready to install
an original heavy duty brass radiator
another used front bumper and a set of doors. a couple pieces of glass and regulators.
used rear leaf springs
3 more matching old used wheels, the fourth out of the set is in the back as the spare.