'74 International Scout II Half Cab 4x4 258 3spd
1974 International Harvester Scout
Technical specifications of International Harvester Scout 1974 | |
---|---|
Price: | - |
Condition: | Used |
Item location: | Brewton, Alabama, United States |
Make: | International Harvester |
Model: | Scout |
Year: | 1974 |
Mileage: | 155,555 |
Engine size: | 258 |
Drive type: | 4WD |
Options: | 4-Wheel Drive, Convertible |
Vehicle Title: | Clear |
You are interested? | Contact the seller! |
Car description |
---|
Have owned the Scout for years and is my daily driver.
I'm sure it has had days off road before me, but the only dirt the Scout has seen since I purchased it is my driveway.
258 AMC straight six w/ 3spd. Runs and drives awesome, Lifters clatter when cold.
Dana 44 front and rear w/ factory 3.73 limited slip.
Does have rust and needs a right quarter panel and floor pans.
Lots of new and used parts also go w/.
Things I have done since I've owned it, I'm sure I'm forgetting some things and will add them onto the description as I remember them.
it has been re-wired w/ a Speedway Motors wiring harness- Sunpro gauges: Tach, Oil, Temp, Volt, Vacuum, Fuel. Optima Red Top
Energy suspension cab mounts and leaf spring bushings. 1" body lift w/ Rough Country add-a-leafs front/rear.
Warn hubs, shocks, brakes, brake master cylinder, braided stainless rear hose, U-joints
US Wheels: 15x8 white mods w/ 31x10.50's. tires are 90 percent. matching spare.
Toolbox has keys
'85 Jeep aluminum intake manifold w/ Motorcraft 2100 carburetor. Jeep exhaust manifold and ran new pipe w/ quiet muffler and tip
'85 Jeep front v-belt drive w/ power steering and GM 10si alternator
GM HEI distributor. fuel pump about 6 months ago. power steering box has a leak on the input shaft, I have the seal, just hadn't had time to replace it. installed the Flaming River steering shaft u-joint kit.
Parts that go w/ it, I'm sure I'm forgetting some things.
Almost perfect, in primer, windshield frame w/ new windshield rubber gasket and new "Anything Scout" stainless wipers
left front solid inner fender, has been painted ready to install
an original heavy duty brass/copper radiator
another used front bumper and a set of doors. a couple pieces of glass and regulators.
used rear leaf springs
new Moog steering drag link and steering dampner. the Scout doesn't need it now, I just grabbed them at a good deal.
3 more matching old used wheels, the fourth out of the set is in the back as the spare.