This car has been my daily driver for about three years. I have driven the car from Austin Texas to Denver Colorado and back. About six months ago I drove the car to Las Vegas Nevada and back. The car is currently licensed and inspected. Since I have owned the car I have replaced the followingCV axles. radiator. alternator. water pump. timing belt. tie rod ends. 4 wheel alignment. 4 new tires. belts. nbsp;catalytic converter. battery. front brake rotors and pads. rear brake shoes. brake master cylinder. nbsp;distributor. spark plugs and wires. Ok. now the bad. The car could use some struts. There is an oil leak somewhere. I believe it to be in the oil pan gasket. Last week I brought the car in the garage to change the alternator. I noticed some type of hydraulic leak. I couldn't tell if it was the power steering or brake system. Both of the reservoirs seemed to be at normal level. Sometimes the check engine light comes on. The code is a code 9 cylinder position sensor. This sensor is located in the distributor. I replaced the distributor with a brand new one. but the light still comes on. Possibly there is a short to ground in the wire. but I have not found the source to date. I have the blue title in hand. License and inspection are current. Please contact me with any questions. If you are in the Austin area. come by and test drive.