1966 Dodge Coronet 500 440 engine Hardtop 2-Door

Relisted due to non-paying bidder.

1966 Coronet 500. 440 with 383 rear wheel hp and 433 rear wheel ftlbs torque, hassis dyno'd at TPIS in MN. That's with air filter, xhaust, nd all accessories hooked up. This car is an absolute blast to drive. It runs and drives great, nd has a clean title with tabs good until September. I've only put about 1000 miles on it this year so I've decided to sell it. I understand this is a very customized car and that it's not for everyone, ut I think it's really cool. I'm embarrassed to say how much money I have into it and unfortunately I know I'm going to end up losing out when I sell it, ut that's just how it goes sometimes. Even my buy it now is less than 1/4 of what I have in this car. This is a no reserve auction!

The body work and paint job are amateur, ut it looks good going down the road. If I was going to keep the car I might redo some of it, ut also it's nice just to get in and use it as is. I tried to show as much as I could in the pictures. The trunk pan has been redone with sheet steel and a reinforced framework underneath. There's some rust and a few missing sections under the car where the subframe connects to the unibody. Shown in pictures. There's also a larger piece of floor pan that was mended on the driver side and a smaller area on the passenger side. Shown in pictures. The tint on the back window has kind of went to heck, nd there's some miscellaneous surface rust under the car that I tried to show in the pictures as well.

Features:

489 rear end with an after-market locking posi. I don't remember which brand.

3:23 gear ratio

Full roll-cage.

Racing seats and harnesses.

Fuel cell in the trunk.

Only 5000 miles on rims and tires.

Front disc brakes.

Brand new easy access electrical system

Polycarbonate front and rear window

B&M Ratchet shifter

Radiator with electric fans from 2006 gto

All new gauges

727 torqueflite automatic 3-speed transmission

Professionally built exhaust system

New shocks

New leaf springs

Engine:

440 HP block

383 rear wheel hp

433 rear wheel ftlbs torque

Aluminum Source heads

800cfm holly carb

MSD ignition

Torker intake

Comp cam # 21-233-4

Oversized push rods

High flow fuel pump

1 7/8 Hooker Competition headers ceramic coated

Aluminum welded valve covers.

The car is currently with me in Spring Creek, V. You are welcome to come get the car, therwise I could potentially deliver it depending on the distance, nd assuming you the buyer would pay for my gas. If you are unsure of transportation arrangements please work this out with me before bidding. My work schedule can vary a bit, o we would just have to settle on a time that would work. I'll deliver it for free to Salt Lake City, T, r Reno, V.