1963 Impala SS Project in Progress No Engine or Transmission

1963 Chevy Impala SS. What is new front and rear back glass. frame off with new brake lines and fuel return setup for a 409 engine. . Front disc brakes and new rear brake linings and wheel cylinders. Suspension is after market Hoskins. new springs. shocks. sway bar and frame has been soda cleaned and painted. Body work for the doors and quarter panels has been completed. Trunk has a new floor pan installed. Has all new American atuo wire wiring harness installed. i. . dash and front clip ignition and light and for a 1 wire alternator and hei ignition setup. Front and rear bumper assembly is new and brackets restored. Has clutch pedals and related hardware. Factory dash and tach 0-7000 rpm tach. Has all interior that is used and needs new interior but all hardware I have. Has a new trunk lid. I have the original hood and front fenders. I have new front fenders and new inner fenders and new hood. I have all the chrome mouldings and new side after market mouldings. I have a new hardware for assembly interior and exterior. I have all parts to assemble car except no grille. I have the head light buckets and the front aparon and lower grille and front hood springs and new battery tray and new yellow cap battery. Lots of other goodies that will go to the buyer. Contact Jack Gibbs 1-530-934-4336 or cell 1-530-228-2470 also have the top rail moulings that are new but not installed. some mouldings have been installed from the rear forward. Has P case housing but posi not installed and new axle bearings both side.