1994 LT-5 BLACKROSE METALLIC CORVETTE ZR1 #131 KING OF THE HILL C4 CHEVY 6SPD

UP FOR SALE: Rare Corvette ZR-1. #131 Blackrose metallic paint. LT-5 6speed 4:10 rear gears.This car runs excellent and isgreat condition. This is a super quick car with 405 h.p. 6spd, nd 4:10 gears.73,450 miles Very clean car inside, nder hood, nd exterior. $26000 or make offer. Clean title and possible delivery. Call or text 304-914-1579

6,939 ZR1 Corvettes were built from 1990 to 1995.

Only 448 were built in 1994.

And only 4 were black rose metallic with a tan interior.

.

This Corvette has a performance computer chip, .10:1 gear and a K&N cold air intake plus filter. These enhancements increase the power output to 430 hp and 400 ft lbs of torque. The 4.10:1 gearing widens the useful power band of the engine by 1000 rpms. The LT5 has a linear power band right up to its 7,200 rpm redline.

This ZR1 should run 0 to 60 mph in the 4 second flat range, he ¼ mile in 12.5 seconds or less and top out at 188 mph. All while maintaining 27 mpg @ 70 mph.

The cars exterior paint is nice. It has various small rock chips and minor scratches. This vette will show better than most autos at the local car shows. The light beige leather interior is in near mint condition. The engine compartment looks like it is new. It has a small scratch on bodyon drivers side rearabove tire and one rim hasbeen curbed lightly.

This car is # 131 and has approx. 73,450 miles on it. The sale includes: Some records, wner's manual, copy of the original purchase invoice .

The car is located near Pittsburgh PA. The price for this ULTRA RARE car is $26,000.00

Contact Todd at 304-914-1579....call or text anytime!

The car has only been driven 1500 miles since over $6,500 in parts & service upgrades were done.

Which includes following new parts:

Factory dual mass flywheel

Pilot bushing

Factory clutch, ressure plate and throw out bearing

Professionally rebuilt Dana 44 with 4.10:1 gearing

Transmission speedometer correction gear

PVC valves

Oil sending unit

Adjustable rear strut rod kit and polyurethane bushings

Factory rated composite rear spring and polyurethane bushings

Two drive shaft and four half shaft u-joints

Clutch slave cylinder

Performance computer chip

Fresh trans and diff fluid

Four Vredestein tires

Four wheel alignment and balanced tires

Pass side rear wheel hub bearing

Additional includes: a new ECU and plug wires at approx. 60,000 miles. The radiator/engine was flushed 2 years ago

The engine was designed by Lotus engineering and manufactured by Mercury Marine in Stillwater Oklahoma. This all aluminum 350 cubic inch displacement, 2-valve, ual-overhead-cam Lt5 V8 is rated @ 405 hp and 385 ft lbs of torque. It also features a 16-runner intake manifold, fuel injectors per cylinder and 11.0:1 compression ratio.

ZR1 Corvettes are 4 inches wider than a standard Corvette. 6 speed manual transmission, elective ride control suspension, tealth radar deflection windshield, assive 315/35/17 tires mounted on 11" wide rims are all standard ZR1 equipment. The sticker price for this vette was $68,743 in 1994.