1986 Toyota Corolla GTS rolling chassis AE86

This car is pretty rough on the surface but I think it would be a pretty good base to do something with.
I bough this car to mock up some parts. I bought it as a roller and never did much digging into it so I don't know anything about condition of things like trans, drivetrain, or things like that.
It does have a transmission and it seems to shift properly. There is a block in the bay basically just holding the trans up.
The wiring harness appears to be all there. ECU is there. I think it just needs a motor and ancillaries slapped in to be a runner and a little work to the brakes and it should be a driver.
The drivers fender is a little busted up and flops around a bit. I don't have the bumper but I did see a grill inside. There are a bunch of other parts inside like dash parts and other interior and exterior parts.
It is missing the passengers seat and back seat bottom.
The doors are hard to open and definitely need a hinge refurb. This is very cheap and easy to do.
Pics attached of the only rust I know of. Holes in front of the back tires on both sides. I don't think it's anything too hard to fix and it doesn't look like it goes too far.
Bring a trailer. Buyer responsible for picking it up and transporting it.It has T3 camber plates and some kind of lowering spring in the front. They look like Eibach coilover springs or something like that but I don't see any adjuster sleeves.The rear springs are aftermarket. Pretty sure they are Swift.
That's about all I can think of. Pic of carfax report attached.