1965 Cobra 427

1965 Cobra Factory Five MK4 replica. Built with all new parts (not a donor car build). This car is powered with a 427 Windsor stroker producing an estimated 600 hp that was professional built by a Engine Masters finalists. The engine is built with the following parts; 4340 forged crank, 4.17 stroke, steel I beam connecting rods, forged pistons, balanced rotating assembly, 10:1 compression (runs well on pump gas), PBM Strikeforce heads with custom port and polishing, hydraulic roller (cam, lifters and rockers)from Erson, powder coated Victory Jr intake manifold, Quick Fuel 750 dual feed, custom powder coated value comer and air cleaner, HEI ignition, billet March pulley set, aluminum water pump, motor sport plug wires, bullet aluminum wire loom holders, new steel flywheel, polished stainless headers and side pipes. New performance clutch and bell housing. New Tremec TKO 600 transmission (rated at 600 lbs of torque) 5 speed with a .68 overdrive. Very strong and geared for top end cruising. New custom built drive shaft. Ford 8.8 rear ended complete upgraded with new; bearings, 3:55 ring and pinion gears, aluminum rear cover with built in cap supports, Yukon 28 spline axles, powder coated housing. Front and rear adjustable coil over Koni shocks, tubular front and rear control arms, Wilwood disk brakes front and rear including pedal assembly. Rack and pinion steering. Rear tires 315/35ZR17< Front tires 245/45ZR17 Halibrand Wheels. The body was professional prepared and painted with PPG paints.This is a new. We are asking $49,900 but are open to reasonable offers. No low ball offers, No scammers. We do not need help selling this car. Please contact by phone only, if I don't answer please leave a voice message. I will not respond otherwise due to scammers. 319-461-0097