1976 Porsche 914 / 914-6 Six Conversion 3.0L

Specs:

1976 914 with a 1981 3.0L SC engine

1966 Weber 40IDA3C Carburetors (36mm main venturis; F26 emulsion tubes; 150 mains; 55 idles and 180 air corrections with 3 degree squirter nozzles)

MSDS 1-5/8 headers

DANSK Muffler Sport Polished Stainless Steel (84 mm Dual Tail Pipes)

901 Side Shift Transmission (Rebuilt by Mike Callas / Rennsport Sealy)

Patrick Motor Sports Engine Mount

Vellios Oil Tank w/ Filler Neck and Dip Stick

Kennedy Engineering Flywheel & Stage II Clutch w/ TOB

MSD 6AL Ignition

Distributor rebuilt and recurved by Barry Hershon (23 crank degrees)

Alternator rebuilt by Houston Alternator

911 Starter

Mocal 25 Row, 235 Matrix Oil Cooler w/ Remote Thermostat

Engine oil cooler modified by Richard Johnson

Valvoline VR1 Racing Oil 20w50

Aeroquip Stainless Steel Braided Hose -16 AN Tank to Engine, -12 AN Everywhere Else

Gates LP (Low Permeation) Carb Fuel Line 5/16"

CB Performance Fuel Pump

3M 1080 Scotchprint Gloss Hot Rod Red Wrap installed by Undergroundgrfx

Turbo Tie-Rods

Bilsteins P36-0112-H0 Inserts

Mahle 5.5x15 Wheels

BFG G-Force Sport Comp 2 Tires (Summer 2016)

Front Sway Bar Installed (Rear available)

Car:

This is a 1976 Porsche 914 that has a 1981 Porsche 3.0L SC engine. Almost all work done to the car has been done by myself (except wrap, bodywork, and specialty rebuilt parts). I have owned the car since 2009. In 2010 I purchased a project 911 to swap the engine to my 914. After preparing the engine and collecting parts the swap was done in the summer of 2014. I have driven this car every fall and spring when there is nice weather. Mileage of engine and car is unknown. Annual driven estimates are 2-4 thousand miles. Engine pulls hard and is a true blast to drive in this tiny car. Previous owners gutted the car for autocross – this is a lightweight 914 with no radio, no A/C, no heat, no electronics, and no comforts. Interior is bed liner – no carpet. I do one or two autocrosses a year. No accidents under my ownership. The car has never been towed home. I also own a 2000 Boxster S that I work on myself as well.

Issues:

Slight rust issues were fixed by my body guy before being wrapped (paint underneath is faded red). Previous rust issues were already fixed before my purchase (battery hellhole). Racing seats need to be recovered or replaced – I have passenger seat but is not in car. The oil tank oil filter mount was not drilled center so I am using a remote oil mount. This allows for extra oil temp sensors that are featured in the center console and for the remote fan. Engine leaks like any classic Porsche engine as does the oil tank through a fitting or mount I apparently didn’t seal well enough when installed. Speedometer is not accurate – bounces around despite new cable. Carburetors run great however the shaft bushings need to be replaced. Wipers move slow but good enough for Texas inspection.

Price is firm. I do not need to sell and very much enjoy this car - I even daily it to work as it's reliable. Please note that most pictures in below photo albums are few years old. Both trunks are now painted and car is fully wrapped. K&N air cleaners are now matching. Engine lid and front/rear valences are available for install. If you want additional pictures then let me know.

Drive by: https://www.youtube.com/watch?v=XIIH5ZSfbTE

Complete engine swap photo album: http://imgur.com/a/k0Wtl

Oil cooler install: http://imgur.com/a/6u4ew