I have a 1967 Pontiac GTO Barn find, I have Pontiac documentation this is the way the car came from GM, Original color is Tyrol Blue Poly exterior with Black vinyl bucket seat with WT 400 335 hp 4 speed 3.55 locking rear axle and hub caps. I have original Numbers matching 400 block and the original rebuilt 670 Heads. Car comes with a 1967 YC with 143 heads 2bl 400, this is a running engine this will give you all parts to rebuild the WT block or put the heads on the YC block. I have most parts but some will need replacement. Car needs total restoration Originally a TX car floor pans are thin by front passengers feet but may be salvageable rear window panel and rear quarters are not too rusty but have a lot of filler. I would replace them and be done with it. The trunk floor is solid but was fixed with flat tin before patch panels were available. The four speed appears to be an M21 out of a 1973 Chevrolet. Main case has number 3925661 cast on it and has a date code of P3B26B, input shaft has 26 spline with 1 grove. I never had the transmission in a running car so I would think of it as a core. Some parts I do not have are Shifter rods, shifter mounting plate, center console, pilot bearing, clutch pivot ball to engine block rings and caps for rally ll rims. I know the black plastic grille surrounds are shot. The trim that is there will work for a driver but will need restoration or replace for show. Somethings not on build sheet and added to the car over the years power brakes, power steering and in dash rally gauges and rally ll rims. A nice real Pontiac GTO if your want a project this would make a nice car that will hold its value. This vehicle is being sold "as is" All shipping charges are buyer's responsibility. Title Information: Vehicles titles may be held by bank If payment is made by cashier's or personal checks we will hold all titles for 10 days or until funds have cleared. |