1938 Plymouth PT57 Commercial Sedan Delivery

1938 Plymouth Sedan Delivery. Been stored inside for 30 years. Only 1601 produced in 1938 The floors in these were mainly wood with steel insert at the front fire wall area. I have all new cross members for the floor area I fabricated from galvanized steel. One original bucket seat. I have front doors that are basically rust free from a pickup. The top back corners are round on the pick up and square on the delivery but its only the outside skin that is different. I have seen these doors sell for $800 a pair in this good a condition. I have the original doors also with the inner window frame trim. The top front of the roof is rusted from a mouse nest and I have a inner & outer section that is rust free for replacing. The lower rocker panels was rusted out so I fabricated replacements and have one installed. I have a good windshield frame. Complete windshield crank-out w/ handle. A handle was just listed on E-bay and sold for $100. I have window regulators & latch controls for all doors plus spares. Single back door has roll down window also. No glass included. Frame is real solid. I don't think it would even have to be boxed for a mild V8. Its 4 spring with solid front axle. Motor and trans are there but I don't believe they have any value. Grill shell is rough at the bottom, Insert is poor. I have all 4 hood sections. Center hood hinge is gone. No hood ornament. I have decent set of headlight buckets that match originals in size and shape but bracket has to be changed. Front fenders are good w/minimal rus, cracks & dents. Rare complete front fender Spare tire mount. There is one frame half of mount listed on E-bay right now for $168. I have 3 rear fenders, I was going to go with the Glass pick-up fenders but the steel ones could be easily fixed. Running boards are shot, reproduction are available. I have the rear interior panels. Clear Kentucky title. Frame stamp, tag and title serial number all match.