1972 PLYMOUTH DUSTER PROJECT

Up for auction is a project 1972 Plymouth Duster "AS IS". 1st off the car currently has centerline weld type wheels on it now. NO KEYSTONE WHEEELS INCLUDED.The pictures you see postedas followed; now, then and how it should look by the numbers. Fender tag has G code 318 motor, B3 code paintstreet basin (Super Blue or Petty Blue) with Twister Duster stripes code, dual snorkel hood and shark tooth grille. I have the original hood with no scoops in the barn butNOSHARK TOOTHGRILLE INCLUDED. I bought the car red, white and blue. Ithad a non running 400 big block with auto trans in it. Holes cut for fender well headers. The rear frame was narrowed. I have a narrowed housing and stock axles that need cut if you want them. Currently has an stock A body 8.75 with a 3:55 center. The motor is a 1974 small block 318with what sounds like a rod knocking. It does run good haven't figured it out yet. 727 trans not sure. Still a Working project. Steel fuel cell. Still not everything hooked up yet either(belts, radiator ect). The lights and brakes work. There is no trunk floor and needs drivers quarter panel. I have a used set of tubs not installed and I have a patch quarter (not the best). I have a drive shaft for it but it will need cut. Decent fenders, doors and floor pans. No headliner or bows. No dash pad. Some hail damage. Typical rust around torsion bar mounts by the trans. I have a complete section included for this area if needed.Tires are aged.It has aB&M shifter installed. The car is not at the point to where it can be restored back to factory or it can befinished out pro street.Dash tag, fender tag and clear title all matches. Ask questions if youfeel serious.Cash deal. $200 non refundable deposit. Depositwill hold it 30 days. Lets deal! I have about $4,000 in it. Anything close to $4,000 will include a complete stock running 1975 HP 440, 727 trans, Hooker Comp fender well headers anda set of 15" X16" Mickey Thompson treaded tires onbrush aluminum centerline type wheels.Thanksfor looking