1986 Mazda RX-7 GXL Coupe 2-Door 1.3L

Im selling my 1986 rx7 gxl the car is primed gray after most of the body work was done. the car still needs some work. I bought the car as a project car and put 3800$ into it to get it to run and look the way it does now. The chassis needs to be fixed on both sides of the floorpan. then derusted and undercoated. That was my next project to do i just don't have the time. I got a estimate for 800$ for doing just welding patches. Not a new floorpan. without the undercoating. It also needs left rear shock. wiper switch only works in one mode. The right corner of windshield leaks. eeds corner seal. there are other small issues with the car as with any used vehicle. What i did to the car: new clutch(clutchmasters fx400 6 puck stage four) slave cylinder master cylinder tune up plugs wires fuel pump fuel filter air filter sunroof port and polish throttle body. bac sensor and solenoid removed they didn't work. cruise control removed cold start removed. to worn the car up hold the gas at 2500 for about a minute then it stays on. The car runs and drives great no issues with the engine and tranny. Since i bought the car. i only put about 500 miles on it. nbsp;i've just been fixing it. I hate to sell it but i just don't have any time to finish it. The picture are from the beginning to now. he pic with the car gray is the latest. I also have all parts that were removed. as for shipping buyer is responsible.