1976 CJ5 Jeep

Moving and need to sell my Jeep. This is a project. R-title. Will sell as not running b/c I don't have the time to put into it.
Jeep was restored before I purchased it. No major rust problems anywhere on it. Good frame and steel body.- 360 motor is from a '76 wagoneer. It smokes a little.- Dana 44 rear, not the amx 20.- Warn locking front hubs- 32 inch tires.- Body mounted rollbar.- Rear seat.- 3 speed transmission.- Hi/Lo transfer case. Works in both Hi and Lo but has trouble shifting between them.- Bikini top and full soft top (if the mice haven't gotten to it yet)- Trailer hitch- Side Pipes
The Bad:- It's been sitting 3 or 4 years.- Dent in front fender.- Dent in hood where it hit the window frame.- Needs gas tank drained- Wiring harness needs finished in the back end and maybe some on the dash.- Mileage listed is since restoration.
Spare parts:A lot came with it. All spare parts may fit in a 4x8 trailer.- 360 motor. Torn down and ready for rebuild- 304 motor. Through a rod in it.- I think there's an AC compressor.- Front disk conversion kit. Came with the jeep and never installed it.- Spare 32" tire, no wheel- Hidden Hitch trailer hitch. Not sure if it's the correct one for this Jeep.
Jeep is available to view in Pottstown, PA (19464).I will not ship this item. Pickup only.Item for sale locally and I reserve the right to end auction early.

On Jan-10-18 at 07:40:06 PST, seller added the following information:

Edit 1/10/18: Some emails have led me clarify more. I had this Jeep on the road and legal before I parked it 3 to 4 years ago. I used it mostly for off-roading. During the time it was parked I started to install a new wire harness. The harness is installed to the point that the motor would run and and a little more, but it's not complete. The motor will run with a batter,y some fresh gas, and a little time but I'm moving and don't have the time to get it going. The Jeep simply needs put back together. To get it inspected you'd probably need to source an E-stop assembly and cable because the roll bar interferes with the stock E-stop assembly. Or you could remove the Roll bar.