1969 Ford Grumman Olsonette bread truck chopped streetrod project

I have come to the realization that I'm probably not going to finish this so I have decided to sell my 69 Grumman Olsonette aluminum body bread truck street rod project. this is a small step van with a 96" wheelbase. it is 13' long. 75" wide. 78" tall overall and the body is 68" tall now. I chopped it 13" in the front and 10" in the rear for that old school wedge look. I had the the 6 piece windshield cut and installed with new rubbers. This van is on a Ford chassis that is set up for a small block Ford and it was a three on the tree. it currently DOES NOT HAVE A MOTOR OR TRANSMISSION IN IT so that means IT DOES NOT RUN OR DRIVE. It has a straight axle front end and I have removed all but one leaf. it still didn't sit as low as I wanted so I have a 04 crown Vic front that goes with it. I also have a Ridetech 4 corner bag setup brand new that also goes with it. The body is pretty straight with its share of bumps and bruises. nothing real bad. the rear doors are cut and installed. I haven't done the side doors as I was playing with the idea of suicide doors instead of the sliding doors like it had. either way would be cool. It came with a 9" rear that is still in it but no center section. I removed the springs in the rear too but i was going to kick the frame to get it on the ground so I stopped there. This is a very cool piece and ugly enough to be real cool. I have a 1988 5. 0 EFI and an AOD that I was going to put in it that will go with it. I will also throw in a Mustang speed density wiring harness and ECM. I have a clear PA title in my name. Will have to be hauled on a trailer. CAN NOT BE DOLLIED OR FLAT TOWED. This van has endless possibilities as a finished product and I would like to see it go to someone that's going to finish it.