1952 Ford F100

Description

This is a 1952 Ford F100 with the 1950 F100 front Sheetmetal, It has installed mustang front suspension and Lincoln Versallies rear end with disc brakes and lowering kit. Has new drive shaft balanced and installed. This has new master brake kit installed and most lines are run except the front disc are not (hooked to the disc) on because of the wheels not being big enough, The truck does roll very easy on these wheels, and will load easy. I have all the disc and rotors for it, The rotors are on just not the disc. It has brand new box with all the stainless for the oak floor which is also all brand new not installed. As you can see it has a new fuel tank mounted between the rear frame rails where it should have been in the first place. It has a jeep tilt column in it but not totally hooked to the dash but is hooked to the front rack and does steer. I bought the truck with this in it and I was thinking of going with a mustang shift on the floor. You will also get that so you can decide which way you like for your self. It has a 2" chop done very nice with the door gaps and roof gaps all fitting like they should. NO Glass . All the fenders were sent to the body shop also and dents removed and epoxy primer applied to keep them from rust. It has new grill and headlights. It also has bear claw latches installed and working great. doors open and shut with ease. Door poppers are installed also. The frame has been cleaned and painted with what looks to be a por system and is very nice. This truck also comes with the brand new wire harness and remote door poppers. The picture shows that there is a 351 c, motor (Fords best small block)and c4 tranny which has all been rebuild with a mild cam edelbrock manifold and four barrel and headers. It has moo cho bucks in it! as you can tell by the parts The gentlemen I bought it from became ill and could no longer finish his dream. It also has very spendy headers. There is a lot of parts that come with this truck and I would bring a truck and trailer so it can be loaded and tied down the right way. Please make sure who ever you send to pick it up can winch it on a trailer and have room for the box parts and chrome. Please if you have any ? on this ask before you bid. I have clean title in my name in MN. If you have less then 10 + feedback do not bid until you contact me!!! if you do I will remove your bid and block you from bidding on it at all. I was going to build this truck but I just have two many projects and I want to get back to my mustang. The big buck stuff has been bought. It will make a Great street rod. I may entertain selling with out the engine and tranny if you like? email me early and we can talk about it, once it hits the reserve it would be too late, Also have the truck listed for sale so auction could end early but if it hits the reserve it goes to the highest bidder!!

On Feb-02-20 at 07:37:09 PST, seller added the following information:

Hi, Just wanted to add to thi, There is a tailgate that goes with it and has had a new bottom welded on to it. It is decent but I was going to buy a new one for it. I do have the sockets the tailgate hangs on but again they are not the best and was going to buy news. You will get both. Also the hood latch is not finished. And the hood will be tied down for travel. Thanks and Good Luck !

On Feb-03-20 at 07:56:09 PST, seller added the following information:

Added one more pictures of parts, Forgot to mention this comes with MSD Ignition. And has a heavy duty wire harness for the new headlights.