1968 Ford F100 Frame off restoration just completed Bored & Stroked 390 to 431

Up for auction is a 1968 Ford F100 Just finished a frame off restoration. Motor is a stroked and bored 390 to a 431 pushing around 700HP has edelbrock heads edelbroke intake and dual carbs. Scat balanced rotating assembly. March performance front billet brackets with billet alt, ac compressor, power steering pump. Built C6 trans with shift kit and 3200 stall. Built to handle the HP. 4-Link adjustable rear suspension with adjustable coil over shocks. 9 Inch rear end with strange engineering nodular iron S center section. Detroit locker. Daytona nodular pinion support. Forged 1310 yoke. Disk brakes on all 4 corners. Frame blasted and painted. Custom covered seat with matching door panels and headliner. Only a couple hundred miles on truck since finished. All new emblems and trim. Rechromed factory front and rear bumpers. Spray in bed liner.
I am sure that I am forgetting a lot of things. I have all pics off restoration and receipts.
Reserve is much lower than what was spent to build this truck. Please email with any q's before bidding.

On Oct-16-18 at 13:26:18 PDT, seller added the following information:

This truck was stripped down to the bare metal then built back up. No metal work had to be done. All the metal on the truck was rust free to start with. It has a custom one off hood on it with dual scoops to let cool air in and hot air out. A lot of money spent to build this very nice truck. The reserve is much less then what was spent on it. Only a couple hundred miles on truck.