1989 ford mustang (roller) roadster

1989 ford mustang gt convertible roller no motor or transmission. purchased the car in 2009 car started out originally as a stock 89 5.0 302 5 speed convertible. completely gutted the car top to bottom to make rear top delete, and weld in roll cage, also shaved the door handles. and reinforce the frame in a few places with frame ties and fully weld the torque boxes, no rust on car at all. all work done on the car was performed by myself and took about 2 years to finish. this car is a blast to drive very little weight over the rear end makes a fun drift car and takes turns very well.
car is set up with a bran new ford racing EFI stand alone wiring harness still wired in car, has A9l computer with sct 4 bank chip installed. seats are out of a 84 with halo head rests. saleen wing and aftermarket 16x9 rims with 255 on rear and 235 on front. has stock suspension just lowering springs. new brakes on front, clapiers rotors,pads and lines. bran new rack and pinion with tie rods. has 8.8 rear end with 3:73 gears stock axles 4 lug still. new brakes in rear drums shoes ect. new master cylinder. has flowmaster super 44 mufflers still hanging under car with chrome tail pipes. also comes with bbk shorty headers and pace setter x pipe with 02s. gas tank is newer with new 155 fuel pump. comes with bran new one piece headlights. newer radiator and p/s pump still under hood. u can pretty much drop a motor and 5 speed in car and go. I no every inch of this car if u have any questions please feel free to ask. car isn't perfect but would be a fun project for someone else that has the time. I really don't want to sell this car I did just have it posted last week and didn't sell so I'm trying again, my daily driver needs a lot of work and I need to try and sell the mustang to pay for repairs.

will aslo be interested in trading car for a used running 5.4 3 valve engine for ford f150