1966 FORD BRONCO UNCUT ORIGINAL JANUARY 66 BUILD

Last time it was driven was in 1989. Mileage is original and not turned over (46483). All initial rough prep work is done and been primed . Floor is non skid liner coated. Winch and power take off (dealer installed) are hooked up and working. Runs. engine and power train are all good. 6cyl 3 speed high low transfer case. Was used by previous owner to service communications repeaters in mountains and I have only had it in storage since 1989 that's why the low miles.( traded repair work for it when I had my shop then) Very straight clean body. winshield is cracked all other glass is good. rubber seals around doors need replaced. any rust it had was replaced with new metal floors are all in very good condition and original except drivers side was already replace when I got it. seats need reupholstered. Rear seat not bolted down.has 2 ant. mount holes in rear quarters and one base mount ant hole in top.. Tires need replaced and missing some lug nuts.White 8 spoke wheels from that era. Front side markers are not original. Mirror mounting brakets have some surface rust on them.Probably needs carb rebuild kit.I'm sure the accelerator pumps dried out .That's cheap and easy fix. Dash has hole in it for extra radios done by previous original owner. tank has no fuel in it and coolant drained in 89 for storage.Great for restoration since rough prep is done already and ready for final paint prep.I have 3 other older than this, ehicles to do so that's why I'm not going any further with this one.That's everything I know to the best of myknowledge. Don't think I forgot anything. Door straps weredisconnected for pic's.IT IS AS IS NOWARRANTY AND BUYER ISRESPONSIBLEFOR PICKUP AND DELIVERY.