1990 DODGE RAMCHARGER 4X4 W/5" LIFT, 38" TIRES, & BRAND NEW 400HP V-8 ENGINE

This truck will be awesome when completed. It has a professionally built 360 C.I. 400 Horsepower engine that was tested and balanced with the brand new Centerforce Flywheel. It has a 4 speed manual transmission out of a W250 3/4 ton truck. It has 5 inches of lift and new Superlift Shocks. It is so close but I am being forced to sell it because I am being sent to Korea for an entire year and can't afford to store it. This truck is very close to finished and could be completed in a weekend. The engine is installed but the drive accessories are not. I will include the alternator and the power steering pump with the truck. It also needs the vacuum lines, fuel lines, and the electrical wiring completed for the engine. The truck has all new front brakes (calipers, pads, bearings, seals, and drilled and slotted rotors). I have the parts to replace the rear brakes and will include them with the truck. The axles have been replaced but the brake lines have not been replaced to the axles. It also needs to have the clutch pedals and linkage installed (it was an automatic- I have the parts and will include them). The only things that I am aware that still needs to be purchased are the front and rear driveshaft (I have the old ones but they don't fit because of the lift and transmission swap), the carburator, and the cooling fan. Everything I have for the truck will be included with whatever the bidding ends at. The engine specs are in the pictures. As stated, the body is from up north and has a lot of rust underneath. I check the frame and didn't find anything worse than surface rust. The Engine, Lift, Tires, transmission, and axles alone cost me over $5100. I am only selling because I can't store it and need the extra cash. Thanks for looking.
AS STATED THIS TRUCK DOES NOT RUN AND WILL NEED TO BE TRANSPORTED/TOWED. I WILL NOT ARRANGE SHIPMENT, THAT IS THE BUYER'S RESPONSIBILITY. MESSAGE ME WITH ANY QUESTIONS.