1972 Dodge Demon Plum Crazy Purple .340 A Body Mopar

1972 Dodge Demon
Project car that I cannot finish but very close to running.
Motor & Trannie:Block magnafluxed, .030 over forged pistons, reconditioned rods, steel crank cut & polished, Mahle Pistons, moly rings, Clevite rod main & cam bearings, Lunati cam, lifters & springs [lift.494 duration 268], hardedned exhaust seats, PC seals, surfaced heads, double roller timing set, aluminum intake, edelbrock 750, new water pump, new fuel pump, 5 quarts Brad Penn 30w break in oil installed, new thermostat, 727 street/strip torqueflight with high stall torque converter.
Will need radiator (not included) Starter & alternator (included but will need rebuild) Driveshaft included but should be spun & balanced. Needs centercounsel for floor shiftier, rear bumper.Right front headlight bucket missing (the attachable kind not the weld on kind.)
Windshieldand new windshield gasket are included but will need to be installed. All engine/front wiring harnesses are new.
Headersare included but notinstalled becausethey are used and I figure you will want to get new ones.
Seats are either A or B body buckets and the driver seat is beat up. Back seat is good. Interior trim and Demon emblem are good. Window cranks, door handles are there.
Front disc brakes with good rims and tires, rear brakes set for drum with OEM wheels-probably easiest to make those disc also.
Been stored inside since I acquiredit on 2005.
Motor at top dead center ready to go. Rear end is Mopar 8 3/4, standard non-posi.
Some parts are not pictured did not have room. Door and floor inside with and without skin/ carpet & padding. Driver seat matches passenger seat but will need to be reupholstered; headliner; gas tank, straps, filler tube. All emblems (2x outside 2x on door) intact. Dash picture shows no glove but it is included, hinge & door. Door picture with skin on-handle was not pictured but I have the spacer & handle for both back and one front, and the other front handle but missing one spacer. Hood-I hand buffed a small spot to show the paint is decenet the hood just got dirty.
Picture is actual item; Paypal deposit required and is non-refundable. Buyer must transport . I can arrangea flatbed buyer pays ALL costs for shipping. I can also finish the car, buyer must pay then produce enough to acquireparts.
To make this car run, all you need is:rebuild (or replace) starter & alternatorradiator & hosesexhaustrear brakesinstall windshieldrear bumpermisc labor
I assume most would want to do more than the bare minimum but just wanted to state that. Also, have a radiator & flowmasters that you are able to pick up from another location if you want them. Also door handles and rear seat skins. No extra cost but you will have to get that separatelythat is not automaticallyincluded. The front doors are complete except for the passengerdoor spacer between the leather handle and door, the back set has both complete arm rests but is missing the leather trim (the metal one is there) and the back seat, headliner & seat beltsfor front look good.
*note*I will have a couple more pictures. Also, eBay had some issue last tim, it screwed up my page views and reserve so lets hope that does not happen again. Lastly, buyer can contact the shop that built my motor and trannie; they have been in business 30 years they do all kinds of custom work and they have done other motors for me I have confidence in their builds. That contact info will be provided to buyer.