1976 Datsun 280Z Roller-Build Race Car-Go Stock-Nice Clean Body. -Solid Project

This is a 1976 Datsun 280Z roller. No drivetrain, no engine, no tranny,no driveshaft. No stock wiring from dash forward.,no gauges other than the Bosch tachometer in there.. I got it in a package deal with some other cars. I have no direct history on it.It had a V8 in it. And looks like they were planning to put another in. New engine bay wiring, new engine bay paint,new brake booster,fairly new radiator and tranny cooler,Has the V8 engine mounts, Poly bushings on moustache bar, stainless brake lines on front with what looks like new calipers.Nice front air dam.The paint on the roof is peeling off along with some thick prep work done before they painted in green. Same on rear quarters. Just thick prepwork before paint. It needs to be all stripped, prepped and painted again to be nice.Car is pretty much rustfree. Has a spot or 2 of rust in floor boards,but nice solid rockers, tailgate shut panel, inner front wheel wells, etc. The floor rails are a bit smushed here and there from poor lifting in the past but are not rusty. The rear wheelwell lips have been crimped in for larger tires in the past.Small dent on front leading edge of hood. Along with a large square cut out for the carb. So while this car is not stock, it would be pretty easy to go back there if you want. Soli, straight clean body to work with, with a lot of upgrades already done. Or keep it V8 and drop your own powertrain in and go.Nice stock rims, nice rubber, not bad interior, dash cap, aftermarket steering wheel, stock ignition,turn signal, light switches on column.The gas tank is out but in the rear of the Z. This pretty much is blank slate you can finish your own way. Bone stock or go hot rod V8. Either way works with a body this clean and nice,I travel around the West Coast with my truck and trailer and might be able to get it to you or close. And can arrange trucking to Long Beach California shippers for overseas buyers for $300. Clean straight title.