1975 Datsun 620 Lil’ Hustler Pickup

L20, 4 speed, short cab, long bed, 68k miles

I started this as a project but life is in the way. Sanded and sprayed rear frame and axle. Replaced all four breaks. Replaced clutch cylinder. Compression looks good (have #s) and cooling system holds pressure.

Will start, but if it sits for too long (month or more) it needs gas pulled up to the carb

Will run, sounds like a sewing machine, no knocks

Will move, but you have to pump up the clutch

Will stop… eventually (bakes need bled)

(*update-- 4-8-18 I started and moved it and the clutch seemed properly responsive)

New and old parts-

Front wheel bearings, shoes, springs, and drums.

Reach shoes, springs, drums, 1 line

Tail gate

Clutch cylinder

Extra starter, fuel pump, carrier beating, blocks for rear axle (would raise height)

Box of misc Datsun break parts (not all for 620)

1975 Owner's manual, service booklet, and Nissan 620 shop manual

Clean Indiana title

Bad-

Break lines need bled

Clutch needs bled

Ebrake disconnected from passenger side

Needs bed, gas tank, and tail lights, bumper put back on (have parts) (currently runs off a boat tank)

Holes in floor pans, bed floor, light on rockers

Will need towed/trailered, it can move under its own power

Bed will be attached for transport with all parts in bed or cab

Pick up only from 46106, 30 minutes south of Indianapolis

$150 deposit within 72 hours

Full payment upon pick up, cash, cashier's check, or money order only