K5 Blazer Chevy Squarebody

Roof does not leak, frame is excellent, body is good it has new rockers and hood with hood pins, has been repainted at some point in its life. Hours and hours were spent shampooing and cleaning the interior back to good condition.
Blazer has new 32x11.5x15 Nankang Mudstar tires, new skyjacker 2.5" suspension lift, new front end parts including all 4 ball joints, tie rod ends, inner and outer wheel bearings, raised steering arm, shimmy shock, all 4 shocks are new to accommodate the lift, and has had a front end alignment. Front and rear axle grease changed, new front driveshaft, new NOS rear driveshaft, new brake hoses all around, new brakes all around, new rear wheel cylinders and hardware, new master cylinder. Transmission & transfer case have been serviced with new fluid, filter, and seals. New driver window motor and seals installed. All power windows function as they should including the tailgate with switch inside and outside. Has new wiper blades also. Is an A/C truck but does not have compressor. Heat is excellent and functions to switch from vent/feet/defrost without issue.
Rebuilt 350 with around 4,200 milesHeads reworked by machine shop in 2012 then packed in grease and stored inside until engine build. Standard 1.94 GM headsStandard bore 4 bolt main 350 from 1972 C10New Eagle crank, bearings, etc.GM standard oil pumpCrower racing cam and liftersCloyes timing setForgot the name of pushrods and rockers but they are new.AC Delco distributorAccel plug wiresAC Delco plugsAC Delco oil filterNew StarterNew BatteryRebuilt Rochester Quadrajet 4 barrel Carb.Ram horn exhaust manifolds with true dual pipes turned down at 45* at rear bumper. Unknown brand of muffler but it sounds good. One Valve seal leaks if it sets overnight but causes no issue other than slight smoke at cold start up.Runs strong and holds 45 psi of oil at warm idleRuns 185-190*F in the summer
Has LED high and low beam lights and light bar. Light bar clamps onto drip rails and can be removed without leaving holes in the cab. Includes an aftermarket billet grill and new in the box catalytic converters.
Drivers door panel is rough Could use new front inner fenders eventually, they are there but aren't show quality. Has old bodywork in driver rear wheel well and I have LMC patch for the area to go with it but it is fine driver quality as is. Tailgate hinge area has been reapaired at some point. Dash is cracked as is typical of these model trucks. No Warrenty implied or stated. Vehicle is sold as is with no returns.