1969 Chevy Pick Up 4 wheel drive 3/4 ton

The following is a listing of everything that was done in the restoration of the truck. It is a 1969 cab with everything else 1968 including the frame. I am asking 10,500.00 for the truck.

1968 Chevy Four Wheel Drive Pick Up

This truck was restored from the bare frame up. Frame is original 1968 ¾ ton four wheel drive . Not fabricated or welded. Frame was sandblasted and painted in black acrylic.

Chassis:

Axles are from 1984 ¾ ton 4 WD chevy. Rear axle is a 14 bolt GM corporate with new brakes and drums re cut . Front is ¾ ton dana with new brakes and rotors cut. Both are 3;40 ratio

Has a one ton sway bar fitted to front axle and custom fabricated brackets on frame.

4 inch suspension lift and new shocks

New u joints front and back

New brake lines with braided stainless flex lines at front wheels. New proportioning valve.

Gas tank behind seat eliminated and a 30 gallon suburban tank fitted to rear under frame with custom fabricated cross member and straps.

NP 205 transfer case. This is the best transfer case available in a light truck

SM 465 Muncie manual 4 speed transmission

Flywheel resurfaced-new clutch plate-pressure plate and throwout bearing

New dual exhaust with headers and flowmaster mufflers.

Engine: rebuilt

1966 Chevy 327 small journal with steel crank. Crank was checked and ground. Block cooked, cleaned and bored. .030

Speed pro flat top pistons, rings, rod bearings, main and cam bearings.

1970 Chevy 350 heads open chamber. Valves redone, new seals, springs.

Edelbrock performer cam, intake and carb with electric choke

Fitted with GM HE distributor, wires, plugs

New High Volume oil pump

Chrome valve covers and air cleaner

Body: all rusted metal removed and restored

New floor with braces from toe boards to rear panel.

New door pillar extensions

New rocker panels

New visor panel

New heater box bottom

Bed treated with rhino liner and also bottom of bed and cab

New chrome front bumper-Black rear bumper

Bench swing back seat reupholstered and new foam, frame blasted and painted

New seals, windows, doors ect. New rubber floor mat and insulation

New instrument panel bezel

New firewall insulation

Sliding rear window

New letters on hood

New lap and shoulder harnesses

This truck is basically a brand new 60s chevy pick up. You can feel the air pressure when you close the door where the seals are all new, it even smells like a new truck inside.

The truck is painted GM medium blue in single stage urethane and the glove box door, door panels and steering column are painted GM dark blue. I had it painted with this type of paint because I intended to drive it off road and use it for outdoor activities. I have never tagged it up and it only has about 50 miles on it since restoration. I would recommend scuffing up the paint and applying a base coat-clear coat paint job. I am selling as is and just trying to get back what I have into it.