1957 Chevrolet Truck, pickup, runs and drives, TX truck, hot rod, cruiser

I bought this truck for my wife from a very close personal friend that has restored hundreds of vehicles. Unfortunately my wife did not take interest in it like I had hoped and I have too many projects already. This is what I know about the truck. It has a small block chevy 350 with fully forged rotating assembly. Cast iron ported camel hump heads w/o accessory holes. edelbrock intake (not sure which series) and holley double pumper carb(not sure on size). Aggressive cam and it Has long tube headers and flowmaster mufflers. Sounds awesome! It has a Muncie 4 speed transmission with a new stage 3 ram clutch kit that has 20-30 miles on it. It has the original rear end with some fairly low gears. not sure on ratio but cruises at 2900-3000 rpm at 70mph in 4th. The transmission shifts great and makes no bad noises. The aluminum wheels are 15x10. The head lights and tail lights work. have a larger primary set of headers that go with it. tires are old and need to be replaced. have new king pins that go with it. Truck starts right up every time and drives fairly nice for an old truck. This thing makes some great power! It is a blast to drive. nbsp;not only is it very quick it cruises nice also. Doors open and close great. I had big plans for a complete build but all I did was install new clutch. I have a complete factory 8. 6" 10 bolt rear end out of a 2005 Silverado that I was planning on installing in this truck as a direct replacement with same bolt pattern and width. It can go with the truck also if desired. ask any questions. It is also for sale locally with heavy interest. will not last long. thanks for looking. I have some start up and walk around videos if desired. just message me. On Jan-14-15 at 13:31:30 PST. seller added the following information:I bought this truck for my wife from a very close personal friend that has restored hundreds of vehicles. Unfortunately my wife did not take interest in it like I had hoped and I have too many projects already. This is what I know about the truck. It has a small block chevy 350 with fully forged rotating assembly. Cast iron ported camel hump heads w/o accessory holes. edelbrock intake (not sure which series) and holley double pumper carb(not sure on size). Aggressive cam and it Has long tube headers and flowmaster mufflers. Sounds awesome! It has a Muncie 4 speed transmission with a new stage 3 ram clutch kit that has 20-30 miles on it. It has the original rear end with some fairly low gears. not sure on ratio but cruises at 2900-3000 rpm at 70mph in 4th. The transmission shifts great and makes no bad noises. The aluminum wheels are 15x10. The head lights and tail lights work. have a larger primary set of headers that go with it. tires are old and need to be replaced. have new king pins that go with it. Truck starts right up every time and drives fairly nice for an old truck. This thing makes some great power! It is a blast to drive. nbsp;not only is it very quick it cruises nice also. Doors open and close great. I had big plans for a complete build but all I did was install new clutch. I have a complete factory 8. 6" 10 bolt rear end out of a 2005 Silverado that I was planning on installing in this truck as a direct replacement with same bolt pattern and width. It can go with the truck also if desired. ask any questions. It is also for sale locally with heavy interest. will not last long. thanks for looking. I have some start up and walk around videos if desired. just message me. There is no rust issues on this truck and buy it now is set at $12000. http://vid915. photobucket. com/albums/ac359/TurboMic05/IMG_7075_zpsycsdl35g. mp4http://vid915. photobucket. com/albums/ac359/TurboMic05/IMG_7073_zpsxb19bi2g. mp4