1968 Camaro - California Car Ready for Paint

Amazing car just a few months of work away from a car show!Have to sell my Camaro project because I am moving and there is no space where I will be. This Camaro is a base model that I was working toward making into an SS Clone. It has the hood vents, he trunk and the fin. I just finished the mechanical work and was just about to ship it off to get painted.- Body work is mostly done with the floor and trunk pans replaced, he front fenders, heel covers and rear quarter panels all replaced. There is some surface rust around the back window that is easily fixable when it goes in to paint. Other than that the body is extremely solid.- The engine is a rebuilt 350 from a mid 80's corvette. It is a fresh rebuild. The engine starts up quickly and runs great. It has an Edelbrock 4 barrel carb on it.- Transmission is an original bullet proof Powerglide- I pulled all the wiring out of the car as part of the restoration and bought a complete wiring kit from American Autowire. I have rewired the engine compartment and was waiting to rewire dash and all the lights until after paint. Wiring kit cost almost $600 and goes with the car along with all instructions.- The interior is completely disassembled in prepration for paint. I have all the knobs etc but was planning to replace them when I re-assembled as they are showing their age.Work done in the last 6 months:- Replaced gas tank- Replaced leaf springs in back to three spring from one spring- Replaced shocks in rear- Converted manual steering to power steering- Has power brakes - repaired and replaced all brake lines- Replaced all interior window components (expensive)- Replaced radiator- New drive shaftCar comes with:- Brand new rally wheels with classic look hubcaps and rings - look great!- all door handles, runk, in, irrors chrome strips, riginal bumpers, new kick panels with built in speakers- all seats etc - ready to be re-upholstered- New front grillDoes not have front or back windows but has door windows and quarter windows. All rollers work fineI don't have a center console but do have the horseshoe shifter that goes with the transmission. Heater core was bad when I pulled it out so that will need replaced. I was actually planning on getting air conditioning installed instead.I regret selling this before it is complete but really don't have a choice. As I said, he plan was to ship it off to get minor body work done and paint and then start re-assembling.CA Title in hand with Planned Non-Operation status.Low reserve so will sell for sure.Dan