1991 BMW 318IS Coupe Slick Top

Details: 1991 318 IS E30, lick top (no sunroof) Red exterior, an interior. Mileage: approx 142,000 Car just had a major overhaul this year. -1995 M3 Engine and 5 speed transmission were professionally swapped in -Brakes were replaced all around, new calipers, ads, nd stainless lines, ac assist conversion with new booster. -Suspension reworked- added front sway bar, &R lowering springs, new control arms and bushings in the front. -Complete new exhaust built for it- Stainless 3" with V band for quick removal. -Aforementioned work (engine, rakes, uspension upgrade) has approx 2k miles since being done. Exterior: No rust and very straight original panels, few small parking lot door dings which could be removed with paintless dent removal if you want it to be perfect. But the paint is beginning to show signs of wear where the clear coat is fading away in spots. The most affected areas are hood and both door- roof is good. No rust. Interior: Seats do show signs of wear and dash has some cracks from the sun. looks like a 1991 that has been well cared for. Engine: -1995 M3 engine "S50B30" - All new OEM engine gasket set -reworked head, new OEM head gasket -S52 headers to facilitate easier swap -Factory 95 M3 harness, 13 "Red label" ecu -Full 3" Stainless TIG welded exhaust, o cats, wo mufflers. Sounds beautiful. Drivetrain: -Vacuum brake conversoin, rand new brake calipers, ads, tainless lines front and rear. -5 Speed manual trans -Limited slip rear diff -H&R Springs -H&R front sway bar -Bilstien struts -New factory 95 M3 clutch -Short shift kit -New reman power steering rack Overall a great running and driving car. Been using as a daily commuter and it is very fun to drive. Feels like it should have been from the factory. Aside from the intake and exhaust appears to have been factory with this engine. Factory unmodified wiring harness and ecu, o splicing. The issues I know of with the car are as follows: -Normal wear and tear, igns of age -The brake bias is a bit off. May just need more bleeding but the car pulls to one side when braking. As mentioned above all calipers are brand new. -General paint condition: Some cracking clear coat and evidence of overzealous detailing on the pass. door. Looks like maybe the edge of a buffer pad burned the paint a little. -With the axle ratio of the rear diff it makes for an amazing autocross car but not so great above speeds of 70+ for commuting as rpm at 70 MPH is around 4000 Can get more pictures if anything specific you'd like to see. Living in Wa has not left me a day without rain to get pictures.

On Dec-19-15 at 00:19:03 PST, eller added the following information:

More pictures of car:  Sides are very straight Pictures of exhaust system. As mentioned above, he spot in question on the passenger door. Not sure if this is removable or not appears to have been too aggressively buffed.  Small ding on trunk lid:  Paint "cracking " on hood.