1964 Ford F100

I'm an honest and fair guy so I'm listing all the bad stuff up front. Despite some of this stuff this is a solid '64 Styleside truck I bought it a couple years ago and replaced a lot of new parts to get it drivable. Ican't find any MAJOR rust issues. It does have some minor rust on the floor pans and a little underneath the rockers and doors. It has some wiring issues. I would re-wire this truck if I were to keep it. Previous owners (Ibelieve I'm the fourth) have done creative things to get the headlights to work. They turn on through a toggle switch. The switches on the dash have been re-arranged. Somedumbass cut the radio holes bigger toaccommodate a modernstereo. Thetaillights and turn signals do not function. Steering column may have come from a different truck. The transmission works and shifts ok but will jump into reverse if in park and sometimes into drive if inneutral. I adjusted thelinkage butcouldn't relieve the problem. The speedometer does not work It has some aftermarketgauges thatdon't function but I do have a replacement dash bezel. Heater does not work. Fan blows but no heat. Some wiper scratches on the windshield. Lots of small leaks around window seals. Rear end has a missing shock mount so I fabbed up a set and welded them on. Id look into a different gear ratio because the engine revs high 50 MPH+ These trucks were geared low from factory. Maybe add overdrive to tranny.Now for the good: I have replaced thecarbuerator fuel pump fuel filter sending unit starter andsolenoid voltage regulator battery battery cables points plugs wiresand cap. The factory 292 has had a top end rebuild starts easy and runs great. Truck runs cool anddoesn't over heat. Brand new steering wheel and center cap (horn doesn't work) put a new horn relay as well. New arm rests. New wheel bearing and grease capsI replaced the king pins and shackles eyes and bushing. kept the leaf spring because they are plenty strong. Installed a new steering damper as well as the drag link and tie rod ends. I rebuilt the entire manual brake system. Flushed the system rebuilt the master cylinder replaced all the rubber hoses brand new wheel cylinders all the way around new pads and springs brand new brake drums. I put new parking break cables and replaced the pull handle too. The parking brake does NOT function. I found a few hard to find parts to remedy this buthaven't installed yet. I took of the rust factorytrailer type mirrors and bought thesleek round style with the bullets on them. The seat had been re-apolstured rightbefore I bought it two years ago. I installed a new ignition switch and had the door cylinders re-keyed to match. Also keyed the lock on the factory tool box. (passenger side at lower bed) Replaced the glove box liner too.I replaced the door seals and window felts too passenger window sometimes falls out of track do to broken tab when rolled down. I replaced the rubber gaskets around the wing windows they are a little stiff to open and close now. Some new parts and used included thathaven't been installed: front windshield rubber rear leaf spring U-bolts (4) front leaf spring rear bushings(2) dash bezels (2) one with speedo other blank lower passenger side door hinge five steel ford rims 5"x15" non matching years originaloil bath air filter Shop manual converted to sheetprotectors in a 3 ring binder operators manual some brake parts to fix the parking brake in rear drums original horn ring original wing side view mirrors (pitted and rusty) dual side steel toolboxBottom line is: This is a great truck to fully restore hot rod or just drive it and have fun. I get compliments everywhere I go in it. Ive invested over $5200 in this truck.$500 non refundable deposit due at end of auction. Im selling locally as well so reserve the right to end auction early.Thanks for looking!