1955 Chevy Hardtop 2 Door Post Project Car Wilwood Rack & Pinion Ford 9”

I am sell my 55 Chevy. I have had this car for many years and I have just lost interest in it. We added upper and lower tubular control arms, rack and pinion steering, 12" wilwood brakes with drilled and slotted rotors along with red dynalite calipers. It has 2" drop spindles and 1" drop springs. The car has ladder bar rear suspension with a ford 9" rear end. I also have motor mounts that move the engine forward 1”.As far as the body goes the only spot on the passenger side is at the base of the windshield pillar(pictured) everything else is good that I can see. The driver side has the same issue at the windshield pillar, also needs a small patch panel at the bottom of the quarter in front of the rear tire. It also has a few small holes in the roof panel directly above that. They look to be very small and easily patched. The panel below the trunk is bent up a bit and will need replaced and there are a very small patch in the passenger side floor board. The inner fenders, hood and trunk all look good along with the driver side fender. The passenger fender needs some minor work above the headlight. I have some doors that go with the car. I believe one is usable and one is probably not worth using. I will have to get them out and get pics. I know the car is ugly but overall it is a very solid car. I tried to take pics of all the bad spots but let me know if you want any specific pics. It is located in Harrisonburg, VA and you are welcome to inspect the car in person. Car has a clear title. Thanks