1967 Land Rover Series IIA 88” Frame off rebuild in 2005

1967 Land Rover Series IIA 88"

Frame off rebuild in 2005

Every nut and bolt was replaced. Frame, ulkhead, oot wells, reakfast, appings are all galvanized, nd all steel components that could be galvanized were.

• British Pacific floor mats

• New windshield

• Fresh paint in pastel green in November 2012

• Inside linexed

• Internal Roll Bar

• Center seat toolbox insert

• under grill apron

• New RH Front wing skin

• New LH Front wing skin

• Heater intake grill

• New doors (galvanized frames) and door locks (anti-burst)

• Pangolin 4x4 sliders

• Pangolin Leather Steering Wheel Cover

• Custom galvanized roll bar

• Galvanizing (bulkhead + misc.)

• Galvanizing (chassis + misc.)

• Alu Door tops, isc.

• New hinges

• Dual Brake Servo upgrade

• Brake Master Cylinder

• SIIA 109 Brake plates

• Torrel Front Disc Brake Conversion

• New Chassis bushing install

• (2) weld-on diff guards

• New Clutch Kit

• F/R Stub Axle and Flange

• HD Dbl. Cardon Front Driveshaft

• HD Dbl. Cardon Rear Driveshaft

• X-Eng X-Brake disc trans e-brake

• AC Delco High Output Alternator

• High Perf. gear reduction starter

• Sealed bulkhead connector kit

• Electronic Distributor

• Solid state voltage stabilizer

• Pangolin AC Delco conversion bracket

• DieHard Platinum Battery

• VDO Gauges (fuel, emp, il pressure, olt, ach, acuum)

• Fuse Box

• Distributor/adapter

• Distributor Drive Gear

• Engine work - adjust lifters, new head gasket

• 2.25 cylinder unleaded head

• K&N AirFilter

• New Rod Bearings

• New fuel tank and fuel sender

• Stainless fuel lines

• Reman Rochester Carb

• LR Series Hand Throttle

• New speedometer cable

• rods/clevis ends

• Parabolic Springs; shocks

• (5) BFG MT T/A KM2 - 235/85/16

• (5) NAS 130 steel wheels

• windshieldwipers