1945 ford hot rod street rod rat rod truck

Here is a 1945 Ford hot rod built in traditional style. Chopped three inches and channeled three inches.It has 289 v8,c4 tranny built. New disk brakes, inch drop front axle, notched rear frame, ew brake, new wire harness, new=lights brakes, ll working, ustom made headers new tires and wheel, ll new brake lines and tranny lines, uilt trann, new shifter, ew drive shaft, 79 gears in the rear, ith all new bearings and seals. New box and tailgate, ith new oak floor and stainless steel bed strips. New taillights, ront single lights are Harley made. The glass is all cut and ready to go in, will get the windshield in for sure but I don't know if I will get time to get the other in, ou will get all the glass with it. The seats are 96 grand am and fit great, here are all new dolphin gauges and gauge panel installed and all working. Has clean clear title in my name (not someone else) Has new aluminum radiator and hoses. New automatic shifter on the floor, ew carpet. The original frame was used and built to fit. comet rear 279 gear rear . mustang 289 engine and rebuilt c-4 tranny. Things to finish . Paint tailgate, ay get that done this week, eeds tailgate latches, he headers are new and complete but will need exhaust finished with mufflers. the rest of the glass installed .wiper motor is in but not hooked up yet. It has a small pan needed to finishes the rear of the bed, nd to be safe odds and ends. I am sure I have missed some things but they are littl, LL the major work has been done on this and It will make a great ROd. Just don't have the time. If you have less then ten feedback do not bid unless you email me first! Item must be paid in full before it leaves my yard and all checks clear my bank first. This truck runs and drive but has not been road tested. Thanks and email me with any ?s This truck was a very near rust free body when I started.

On Oct-19-15 at 15:50:20 PDT, eller added the following information:

Update, he truck went in for the windshield glass and back glass today, hat will be done for sure, will most likely notnot get to the side glass although they are all cut and you will get them, lso I got the wire all tugged in and the kick panels put in today. (I will get another picture of them ) They will needcarpet put over them, hey are 1/4 inch plywood and will look COOL! It went down the road good and the tranny shifted great, he carb will need a little tuning yet and it only has old plug wires so you may want to change them, did not get around to getting the spark plug wire brackets that I wanted so did not change the wires yet, o not have any new ones either. Happy bidding Bid soon cause it may sell here first, f it hits the reserve it will go the distance of the auction.

On Oct-22-15 at 07:50:57 PDT, eller added the following information:

Glass update, ack window is in and the windshield is just about done,(It will be done by the end of the auction for sure) If it does not hit the reserve I will finish itand sell in the spring at a much higher price, id now if you want to save! Thanks and GOOD LUCK