1969 Ford Mustang Coupe Project

I hate to part with this vehicle but I've made no progress in the 10 years I've owned it. It's in the same condition I bought it, hich was an incomplete restoration. The prior owner had intended to race this vehicle, ut it became apparent that they never got that far. According to the Marti auto report I purchased, his was delivered as a straight 6 with manual transmission and 4-lug hubs. There is a rebuilt 302 (according to the last owner), 6 (haven't confirmed), " (again haven't confirmed) and 5-lug hubs all around. Minimal surface rust. There is some pitting in the rear floor and a small hole (smaller than a dime). Any other rust is more like "flash" rust. While kept outside this vehicle always remained covered.Update: I believe there may have been repairs done to the lower rear quarter (drivers side) just behind the wheel. I didn't catch this before due to lighting and the inside needing cleaning up. I found what looks like a rivet. I'm assuming this was used to pull a dent out. It's the only place I've found so far that appears to have been repaired.Most, ossibly all, arts are there for completion. Included are new padding and covers (black) for the front seats and headrests. New door panels (still in box). New carpeting, ront and rear pieces. Rear seat is in good condition. Best I can tell this is a very clean and straight body. I've done the "tap" test and used a cheap magnet to check for bondo and couldn't find any spots (other than noted above). There is a new windshield and side glass. Images are taken in a manner that you can see how straight the sheet metal is.If you have ANY questions, lease ask before bidding. This vehicle is sold AS IS, nd being a project vehicle there is NO warranty or guarantee.If I'm able to identify the engine, ransmission and rear axle I will add to the listing. I will include images in hopes that others might be able to identify the parts.Buyer responsible for shipping/transportation of vehicle.Thank you and good luck.