1966 Chevrolet Corvette Coupe Project

1966 Chevrolet Corvette Coupe Project.I bought this car and then found a 65 Coupe and I will beRestomodding the 65.This car is an Original Silver Pearl on Black car.Original Trim Tag and Vin TagGreat Frame and Birdcage.Good Rubber with Very Nice Wheel Covers.Car has had some work on nose but still retains original inner fenders and bonding strips.Nose of car sags a little due to the fact it has sat without the Support RodsWhich I have purchased but not installed.Hood sits a little low compared to body but this could be caused from No shims being under the Core Support which I have also purchased but not installed.Car will need straight forward body work and paintCar has a Rebuilt 1966 Corvette 327/350hp Engine in it and a 4 speed.Engine is dated after the car but has an original corvette Vin stamped in the block.Headlight motors are there but will need rebuilding.Bumpers are excellent coresUnder hood wiring harness,Overflow Tank,Wiper motor etc is all there.Will need exhaust.Nice Driver Quality Interior.Doors open and shut nicelyGlass is all good.Missing 1 Small corner of front windshield StainlessNo Grille,Spare Tire Carrier or Jack.Brake Caliper cores are also thereCar DOES NOT come with rear lower exhaust panel,I am keeping it for my 65.It will come with a very nice rear exit panelOverall a Very nice starting spot for someone wanting to build a Coupe.If your looking at this then you know Coupes are hard to come by.Car will not leave my possession until all funds have cleared my bank.No Exceptions